Veneered Blockboard
These panels are available faced using any of our full range of over 250 veneers & inlays , and can be supplied in industry standard sizes and/or produced to specific sizes to suit your particular needs.
We can finish the edges of our veneered blockboard with matching veneer, which is applied after the face veneers have been applied, or we can edge them using matching solid lumber, which can be applied before the face veneers have been bonded to the core, in order to give a concealed, more robust edge that looks more like solid lumber - this will allow a profile to machined to the edges (e.g. chamfer), while keeping the advantages of an engineered product.
As an alternative, we can edge the panels after the panels have been pressed using a matching or contrasting lumber, leaving the strips exposed for a breadboard edges effect (e.g. Figured Maple with an exposed American Black Walnut lumber edging).
Finally, we offer an extensive range of inlays that can be inserted into the face of these veneered blockboard panels. These can be installed in any configuration or design that you might like, to give a panelled effect, in a more ornate or specific arrangement, or simply to show as vertical or horizontal lines across the face.
Thickness range:
From 12mm to 55mm (up to 100mm thick if more than one sheet bonded to form the core)
Standard sizes:
2440x1220mm, 3130/3530/3670x1860mm
Also available produced to specific sizes
